Playing Arpeggiator Sequences
1. Switch on the Arpeggiator by pressing the ARP (Edit) button on the keyboard.
2. Press a number of keys to start the Arpeggiator.
3. The Arpeggiator automatically plays back the notes corresponding to the pressed keys as a
sequence, rather than simultaneously.
Editing Arpeggiator Parameters
You can also edit the Arpeggiator parameters in the Control section for further tweaking of the se-
quence:
1. Press SHIFT + ARP (Edit) to map the knobs of the Control section to the Arpeggiator pa-
rameters.
2. To change the direction of the sequence to e.g., UP-DOWN, turn Knob 2 (TYPE, by default
set to UP).
3. To adjust the OCTAVES reach of the Arpeggiator, turn Knob 6 (by default set to 1) to e.g., 4.
The notes corresponding to any keys you press are played back as a sequence, up and then
down again over four octaves.
4. To map the knobs to Instrument parameters again, press PLUG-IN. The Arpeggiator will still
be switched on.
13.2. Editing the Arpeggiator
The Arpeggiator’s parameters give you many possibilities to shape your own note sequences.
• To edit the Arpeggiator parameters in the KOMPLETE KONTROL software, click on ARP in
the Perform panel so it is highlighted.
• To enable Arpeggiator Edit mode and map the Arpeggiator parameters to the keyboard’s
Control section, press SHIFT + ARP (Edit).
You can now edit the Arpeggiator parameters on the keyboard’s Control section. Note that
the Arpeggiator Edit mode consists of two pages.
Available Arpeggiator Parameters
• To switch between Arp and Note Repeat mode and change the playback direction of the ar-
peggiator sequence, use the MAIN parameters Mode and Type.
• To create interesting rhythms for the arpeggiator sequence, use the RHYTHM parameters
Rate, Sequence, and Swing.
Smart Play – Playing and Editing Arpeggiator Sequences
100
To Next Page
Loading...
Need help?
General
