9. WORKING WITH EFFECTS
In this section you learn how to work with the Plug-in chain in terms of adding Effects, and organiz-
ing the Plug-in chain. Also, this section assumes you are familiar using the Browser and already
loaded an Instrument.
For more information on using the Browser, refer to Browsing the Library.
9.1. Opening the Plug-in Chain Panel
In order to work with the Plug-in chain in the KOMPLETE KONTROL software you need to make
sure the Plug-in chain panel is displayed.
If this is not the case you can display the Plug-in chain panel by the following action:
• Click on the Plug-in chain panel button in the Header.
The Plug-in chain panel and the loaded Instrument are displayed. You can now add Effects
to the Plug-in chain.
9.2. Adding Effects
Once an Instrument, Loop or One-shot has been loaded into the first Plug-in slot, you can then
add Effects to the Plug-in chain. To add an Effect to the Plug-in chain:
1. Click on the empty Plug-in slot to select it.
Working with Effects
63
To Next Page
Loading...
Need help?
General
