NCE Power Pro - Page 75

75
PROGRAM MACROS
(Shortcut = PROG 8)
This allows the operator to program Macros (switch lists).
SELECT MACRO PROGRAM OR REVIEW
Press 1 to program a Macro or press 2 to review a programmed Macro. If 1 is pressed
the following screen is displayed.
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PM
1=PROG 2=REVIEW1=PROG 2=REVIEW
1=PROG 2=REVIEW1=PROG 2=REVIEW
1=PROG 2=REVIEW
ENTER THE MACRO NUMBER
Enter the Macro number that you want to program (0-255), and press ENTER.
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PMMACRO: 02:00PM
MACRO: 02:00PM
MACRO NUMBER:_MACRO NUMBER:_
MACRO NUMBER:_MACRO NUMBER:_
MACRO NUMBER:_
ENTER THE ACCESSORY ADDRESS/LINKING MACROS
Enter the Accessory Address that you want to control, and press ENTER. A macro can
be linked to another macro by entering an accessory address of 9999 at this point. You
will be prompted for the macro number to link.
MAC: 000 02:00PMMAC: 000 02:00PM
MAC: 000 02:00PMMAC: 000 02:00PM
MAC: 000 02:00PM
ACCESSORY #: _ACCESSORY #: _
ACCESSORY #: _ACCESSORY #: _
ACCESSORY #: _
You can chain as many macros together as you like but use caution. If you chain macros
in a ‘circular’ fashion the system will appear to crash (it is busy sending macros
continuously) until you press PROG/ESC on the cab that issued the macro. If a computer
is used the only solution is to cycle the power to the system and fix the circular
reference.
SELECT THE TURNOUT POSITION
Press 1 for Normal or 2 for Route.
MAC: 000 02:00PMMAC: 000 02:00PM
MAC: 000 02:00PMMAC: 000 02:00PM
MAC: 000 02:00PM
ACC: 001 1=N 2=RACC: 001 1=N 2=R
ACC: 001 1=N 2=RACC: 001 1=N 2=R
ACC: 001 1=N 2=R
The above two screens will repeat up to 10 times to allow you to enter up to 10
accessories. After 10 accessories have been entered the SELECT MACRO PROGRAM
OR REVIEW screen will be displayed. If you want to enter less than 10 accessories,
leave the accessory # blank (just press ENTER).
If 2 is pressed on the SELECT MACRO PROGRAM OR REVIEW screen, the following
screen is displayed.
ENTER THE MACRO NUMBER TO BE REVIEWED
Enter the Macro number that you want to review (0-255), and press ENTER.
REVIEW: 02:00PMREVIEW: 02:00PM
REVIEW: 02:00PMREVIEW: 02:00PM
REVIEW: 02:00PM
MACRO NUMBER: _MACRO NUMBER: _
MACRO NUMBER: _MACRO NUMBER: _
MACRO NUMBER: _
REVIEW MACRO
The Accessory number and output will be shown. Press ENTER to see the next
Accessory in the Macro. If there are no more Accessories in the Macro, the following
screen will be displayed.