NCE Power Pro - Page 74

74
PROGRAM ACCESSORY DECODERS
(Shortcut = PROG 7)
This allows the operator to set Accessory Decoder CVs while they are connected to the
Track (Accessory Programming on the Main).
ENTER THE ACCESSORY ADDRESS
Enter the Accessory Decoder address and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ACC. ADDR: _ACC. ADDR: _
ACC. ADDR: _ACC. ADDR: _
ACC. ADDR: _
ENTER THE CV NUMBER
Enter the CV number that you want to program and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER CV NUM:_ENTER CV NUM:_
ENTER CV NUM:_ENTER CV NUM:_
ENTER CV NUM:_
ENTER THE CV VALUE
Enter the value you want in the CV and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _
Accessory OPs programming now issues both the old “legacy” (5 byte) OPs command for
accessories plus the “new” accessory OPs command (6 byte).
The old command could only address accessory decoders in groups of four. The new
command can address one single decoder address. For the new command to work your
accessory decoder must support the new packet.