NCE Power Pro - Page 78

78
PROGRAM SIGNAL DECODERS
(Shortcut = PROG 0)
This allows the operator to setup Signal Decoders while they are connected to the Track
(Signal Programming on the Main). Address 2044 is the broadcast address for signal
decoders.
ENTER THE SIGNAL ADDRESS
Enter the Decoder address and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
SIGNAL NUM: _SIGNAL NUM: _
SIGNAL NUM: _SIGNAL NUM: _
SIGNAL NUM: _
ENTER THE CV NUMBER
Enter the CV number that you want to program and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER CV NUM: _ENTER CV NUM: _
ENTER CV NUM: _ENTER CV NUM: _
ENTER CV NUM: _
ENTER THE CV VALUE
Enter the value you want in the CV and press ENTER.
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PMPROG ACC 02:00PM
PROG ACC 02:00PM
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _ENTER VALUE: _
ENTER VALUE: _