4-64
Firmware Update
You can update applet, KVM firmware, BMC firmware, sensor data records (SDR), and platform information (PIA)
Starting Up the Firmware Update Window
When you click [
], the icon to start up Firmware Update, on Control Panel, revision information is loaded from BMC, and
the Firmware Update window as shown below appears.
When you click [Cancel], the Firmware Update window closes without any changes made.
The following pages provide information about update procedures.
Loading Update Data Files
When you click [
] to add update files, a window as shown below opens prompting you to select files.
Select update data files.
When you click [Open] after specifying files, loading of the files begins.
It will take a little while for loading to be completed.
NOTE: Because update can be made globally for each update target, make sure to load
everything you need.
You can specify multiple files to be loaded simultaneously.
To Next Page
Loading...
