9-6
Installation
T eps to install a hard disk drive. This procedure applies to all the slots. ake the following st
NOTE: Any hard disk drive can be installed or removed in or from the server only by removing
the front bezel without pulling out the server from the rack. In RAID1 or RAID5 configuration, the
hard
disk drive can be installed or removed while the server is being powered.
IMPORT
ANT: In the disk array configuration, use the same model of hard disk drives.
1. See the s
configura
2. Unlock the front bezel with the security key, and remove the front bezel.
3. c
The The SCSI IDs assigned to the slots are all determined (SCSI ID 0 to ID 4 from right to left).
4.
ection "Preparing for Installation and Removal" described earlier to prepare (except for disk array
tion).
Lo ate the slot in which you are going to install a hard disk drive.
server has five slots.
Unlock the hard disk drive.
5. Firmly hold the additional hard disk drive and
IMPORTANT:
handle, and insert it into the slot.
Push the hard disk drive until the
Carefully hold the hard disk drive
handle hook butts to the frame.
with both hands.
6. Slowly close the handle.
The handle is locked when a "click" is heard.
IMPORTANT: Be careful not to ge
t your finger caught between the handle and tray.
To Next Page
Loading...
