9-23
Non-hot-plug PCI Boards
T lling or removing a non-hot-plug PCI board.
In tallation
T teps to install a board in a PCI board slot.
his section describes the procedure of insta
s
ake the following s
IMPORTANT:
PCI board slots #6 to #9 can accept 3.3V and universal PCI boards.
P V and universal PCI boards. CI board slots #1 and #2 can accept 5
NOTES:
Before installing the PCI board, make sure that the terminal section of the board mates with the
connector of the PCI board slot.
T installed between the PCI board slots. They are for protecting the PCI board
a lled. Take care not to remove or damage the insulator when installing or
r
he insulators are
lready been insta
emoving the PCI board. If the insulator is taken off, reinstall the insulator in place.
1. See the section
IMPOR
"Preparing for Installation and Removal" described earlier to prepare.
TANT: To avoid damage to the system and devices, always turn off the system before
installing the non-hot swap board.
2.
3.
Remove the rear access cover.
4. Locate th
5. Press the over to unlock and open the tab.
tab to 90 degrees or more. Doing so could damage the
Pull out the server from the rack.
e slot to install a board.
retention tab at the tip of the additional slot c
IMPORTANT: Do not open the retention
tab.
6. Remove the blank plate.
IMPORTANT: Keep the blank plate being removed for future use.
To Next Page
Loading...
