9-26
Requirements for Hot Add
ame bus
vices and their Available Slots", and then hot-add the PCI
card
PC
Prov k.
Status Lam
T LED indicators on the back panel indicate the status of the hot-plug PCI add-in boards. You can check the indication by
la
PCI slot Power lamp (green)
er)
t containing the PCI board.
Flas Remove or Hot Replace.
No boards installed in the s
Verify the available slot according to "List of Optional De
.
I boards installed on the same bus
ide Hot Add for PCI boards operating at the same cloc
ps
wo
mps on the I/O board.
Lights when power is supplied normally to the PCI board installed.
PCI slot Fault lamp (amb
Lights when an error occurs on PCI board or the slo
hes when the driver is stopped from Windows Server 2003/Windows 2000 for Hot
PCI slot Power lamp
PCI slot Fault lamp
Hot Add
Take the following procedure to execute Hot
1. Pull out the server from the rack
2. Remove the rear access cover.
3. Locate the slot in which you are
TE: Confirm that the PCI Slot Power lamp of the slot in which you are going to install the
Add:
with the power being on.
going to install an additional board.
NO
PCI board is off.
4. Push the tab at the tip of the additional slot cover of th
the tab.
e slot in which you are going to install the PCI board to unlock
so could damage the
the tab. Open
IMPORTANT: Do not open the retention tab to 90 degrees or more. Doing
tab.
To Next Page
Loading...
