9-25
10. Reinstall the removed components.
11. Turn on the power of the server. Then make sure that any error message does not appear in POST.
a e error message list in Chapter 8.
12 art the B
i
Rem
Remove the b
H Board
O oard while the server is operating.
O -T Adapter support the Hot-plug PCI function.
The PCI hot-plug function includes the following functions:
Plug PCI board while the server is operating.
operating.
NT:
If n error message appears, write down the message and review th
. St IOS Setup Utility to set the "Reset Configuration Data" in the "Advanced" menu to "Yes."
Th s is required to update the hardware configuration information. See Chapter 4 for details.
oval
oard in the reverse procedure of the installation.
ot-plug PCI
n the PCI board slots #6 through #9, you can replace or add a hot-plug PCI b
nly the 100BASE-TX Adapter, the 100BASE-TX Adapter and the 1000BASE
Hot Add
Use Hot Add to install a Hot
Hot Remove
Use Hot Remove to remove a Hot Plug PCI board while the server is operating.
Hot Replace
Use Hot Replace to replace a Hot Plug PCI board while the server is
IMPORTA
Before removing a PCI board, be sure to stop the driver of the slot (containing the PCI board) from
system (Windows Server 2003/Windows 2000). Failure to do so may cause the system
PCI Hot-plug function. The system fails to return to the original state when a function in
Select [Advanced] → [PCI Configuration] → [Hot-plug PCI Control] → [Reserving memory space
fo ry space for installed board*
1
.
*1
T x
The b able for the hot add varies depending on the clock rate previously set by PCI slots #6
and #
P
syste
optim
the operating
to fail.
For Windows Server 2003/Windows 2000 server, do not use a function in inactive state after
executing the
inactive state is restarted.
Use the BIOS Setup utility to set the following before executing the PCI Hot Plug function:
r PHP] → Select memo
The memory capacity appears to be less than the actually installed memory capacity.
o e ecute the PCI Hot-plug function, be sure to login the system as Administrator.
oard avail
7 or #8 and #9. If a PCI board operating at a different clock rate is subject to the hot addition, the
CI slot fault lamp goes on and the hot plug cannot be performed correctly. However, restarting the
m allows BIOS to ignore the setting value and automatically operate the system with the
um setting.
To Next Page
Loading...
