9-28
The insulators are installed between the PCI board slots. They are for protecting the PCI board
a d
rem
lrea y been installed. Take care not to remove or damage the insulator when installing or
oving the PCI board. If the insulator is taken off, reinstall the insulator in place.
8. Connect the c
9.
10.
ess the PC nce and then, goes on.
ables to the PCI board while firmly holding the PCI board with your hand.
Slowly close the tab to secure the PCI board.
Pr I Hot Plug switch. The PCI Slot Power lamp flashes o
NOTES:
If the server runs on Windows Server 2003 or Windows 2000, the operating system
a cognizes the additionally installed PCI board and installs the driver.
I the installed board or slot, the PCI Slot Fault lamp goes on (amber).
utomatically re
f an error occurred in
11. Reinstall the rear access cover and place the
12. Take the following steps to check if the ad ating properly:
(1) Select [Control Panel], [Administrative nager] in the order to
start the Device Manager.
(2) Move the cursor to the added board.
server into the rack.
ditionally installed PCI board is recognized and oper
Tools], [Computer Management], and [Device Ma
To Next Page
Loading...
