9-29
(3) Click the [General] tab to display the property to confirm that the device is normally operated.
on the location of the PCI board slot.
* The message in the "property" depends
Hot Remove
Take the follo
1. Take the following steps to stop the device driver used by the Hot-plug PCI board you want to remove:
ANT: Before removing a PCI board, be sure to stop the driver of the slot (containing
wing procedure to execute Hot Remove:
IMPORT
the PCI board) from the operating system. Failure to do so may cause the system to fail.
To
(1) Open [Add/Remove Hardware] in [Control Panel].
stop the device driver from the operating system window:
Th
(2) Cli
e [Add/Remove Hardware Wizard] starts.
ck [Next].
To Next Page
Loading...
