9-31
(7) Click [Finish].
e rack with the power being on.
and locate the board to be removed.
the PCI Slot Power lamp of the target PCI slot is off.
(8) Pull out the server from th
(9) Remove the rear access cover
NOTE: Confirm that
To stop the device driver using the PCI h
(1)
(2)
(3) Press the PCI hot-plug switch on the slot from which the PCI board is to be removed.
NOTE: Confirm that the PCI Slot Power lamp of the target PCI slot is off.
ot-plug switch:
Pull out the server from the rack with power being on.
Remove the rear access cover and confirm the slot to remove the PCI board.
2. Dis
3. Pus ta
connect all the cables from the PCI board.
h the b to unlock it, slowly open the tab, and then remove the PCI board.
IMPORTANT: Do not open the retention tab to 90 degrees or more. Doing so could damage the
tab.
To Next Page
Loading...
