9-45
Memory Hot-Plug Feature 1 (Hot Replace)
In d memory RAID configuration, the memory board can be
re
oval" described earlier to prepare.
2.
3.
mo
the memory redundant configuration such as memory mirroring an
moved while the operating system is running.
1. See the section "Preparing for Installation and Rem
Unlock the front bezel with the security key, and remove the front bezel.
Re ve the two screws and then remove the memory slot cover.
4. Press the Attention switch corre
The memory board power lamp
sponding to the memory board to be removed.
and the memory board redundancy lamp for that board go off.
5. Make sure that the memory board p
IMPORTANT: The memo
ower lamp goes off, then remove the memory board.
ry board becomes very hot while being powered. When removing the
board, turn off the power and wait for
Note that the hot-plug me
several minutes in this state.
several minutes before pulling it out.
mory board is off-powered when it is unlocked (the LED goes off). Wait
To Next Page
Loading...
