9-46
6. Hold the ejector and pull the memory board out from the server.
7. To set back the memory boar moval
procedure. Then, press the Atten ts flashing,
and after a while, it goes on. Th
IMPORTANT: To set b
ds in redundant configuration, install the memory boards in reverse order of re
tion switch on the memory board. The memory board Power lamp star
e Memory Board Redundancy lamp goes on.
ack the memory boards in redundant configuration, be sure to install the
boards so that they can have redundancy.
8. Install the memory board in rev
This completes Hot Replace of memory
erse order of the removal steps.
board.
To Next Page
Loading...
