2-24
For example, the SCSI BIOS setup utility must be used in the following cases:
I
C for 3.5-inch file device in the server
and
Mo
If the
When mo server, the messages indicating the
star
PCI
PCI
3. Displa
4. If on
setu
r isk array
n
it
nstallation of an SCSI device in the 3.5-inch device bay
onnection of an external SCSI file device (The removal of the SCSI cable
the connection of the SCSI cable coming with the server (for external connection) are required.)
dification of SCSI device connections within the server
again.
SCSI BIOS setup utility is terminated, the server runs POST from its start
re than one SCSI controller boards are installed on the PCI bus of the
ts of the SCSI BIOS setup utilities for the installed boards appear in the following order:
slot number PCI #3, PCI #4, PCI #5, PCI #8, PCI #9, PCI #6, PCI #7, on-board RAID controller ;PCI #1 and
#2. See Chapter 9, List of Optional Devices and their Available Slots for details of boot priority.
ys the SCSI ID numbers used by the connected SCSI devices on the screen.
e or more disk array controllers are installed, displays the message prompting you to start the Disk Array BIOS
p utility.
Sta t the utility according to the message if you need to change the settings. Refer to the manuals of the d
co trollers for details.
W hout any entry, any of the following messages appears.
NOTE:
When you press Ctrl and any other keys during POST to start configuration utility or others, the
the operation.
key entry rarely becomes invalid. If it occurs, press Ctrl again to resume
5. Dis connected keyboard and mouse.
6. Displays owing messages.
Pattern 1:
plays the message notifying you of the detection of the processor and the
any of the foll
Press <F2> to enter SETUP or <F12> to Network
Pattern 2:
Pr <F12> to Network
Or
Pattern 3:
ess <F2> to enter SETUP, <F4> Service Partition,
Press <F1> to resume, <F2> to enter Setup, <F12> to Network
Pattern 4:
Press <F1> to resume, <F2> to enter Setup, <F4> Service Partition, <F12> Network
* The displayed messag
y vary depending on the device status.
e
ma
To Next Page
Loading...
