2-25
NOTE: The operation or utility to be started at each key entry is described below. These
oper
E
Press y the boot menu at the end of POST. This menu allows you to select the
b
ations or utilities may not always be started.
sc
Esc to displa
oot device.
Boot Menu
1. CD-R
2. +Rem
3. +Hard
4. IBA G
5. IBA G
OM Drive
ovable Devices
Drive
E Slot 0B20 v1222
E Slot 0B21 v1222
<Enter Setup>
F2
Press F2 to start the BIOS setup utility. Start the utility to change the setting of the server in
order to fit to the environment in which the server is used. This setting needs not be changed,
unless it is displayed along with an error message. See Chapter 4 for the setting procedures and
fe the parameters.
F4
Press
6 for
F12
Press
F
If me
mess n the messages and the proper actions against the
errors. F1 allows the BIOS setup utility to be started.
atures of
F4 to start the Off-line Maintenance Utility from the maintenance partition. See Chapter
the maintenance partition.
F12 to run the network boot.
1
ssage "Press <F1> to resume" appears, an error is detected during POST. See "Error
ages during POST" for the information o
essage appears, pressing
If an error m
7. When a passw the screen prompting you to enter the password appears
after the norm mination of POST.
The passwor
cannot be sta
to start the se
IMPORTANT: Set the password only after operating system is installed.
ord is set in the BIOS setup utility SETUP,
al ter
d can be entered for up to three times. If you enter the password incorrectly all the time, the server
rted. In this case, turn off the power of the server, wait for about 10 seconds, and then turn on the power
rver again.
8. ar
POST Erro
When POST rror message on the display unit screen. See Chapter 8 for POST error codes.
IMP
St ts operating system at the termination of POST.
r Messages
detects an error, it displays an e
ORTANT: Take a note on the messages displayed before consulting with your service
representative. Alarm messages are useful information for maintenance.
To Next Page
Loading...
