CHAPTER 1 GENERAL INFORMATION
– 26 – NWA-008841-001 Rev.5.0
90ch1001.fm
Application Processor Card Name and Function
NOTE: When using the firmware program of SC-3591 IPS IPTT PROG-B1 or later for the PN-8IPTA
card, you may set the Auto Negotiation ON/OFF settings by the SW0-3. When using the firm-
ware program of SC-3249 IPS IPTT PROG-A1 for the PN-8IPTA card, Auto Negotiation func-
tion is always set to ON.
Continued on next page
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-8ETIA HUB In-Skin HUB Card
PN-8ETIA: Ethernet 10 Mbps/100 Mbps automatic change
MDI/MDI-X automatic change
L2 Switch function (Auto-Negotiation fixed)
PZ-M675: PZ-M675 card is mounted on PN-8ETIA card.
Power over Ethernet (PoE) : All Ethernet port
NOTE: Power over Ethernet (PoE) function is based on IEEE
802.3af and the NEC standard.
PN-2ILCC ILC 2-line ISDN Line Circuit Card
Provides a physical interface to ISDN Terminals.
Occupies 8 time slots per one card.
This card does not require PN-SC03-B (ICH) card.
PN-8IPTA SIP 8 channel SIP Trunk Card
When mounting 24DSP (PZ-24IPLA) card, this card provides up
to 32-channel of SIP
By the office data setting, changes the setting of the card in 8
channel units.
10BASE-T/100BASE-TX twisted pair cable is connected directly
to this card.
Provides Auto Negotiation function. NOTE
• Always set to OFF
• Set to ON/OFF by the switch setting
[Series 3600 software required]
EQUIPMENT NAME AND FUNCTION
To Next Page
Loading...
