CHAPTER 1 GENERAL INFORMATION
– 27 – NWA-008841-001 Rev.5.0
90ch1001.fm
Application Processor Card Name and Function
Continued on next page
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-IPTB IPT IP Trunk Card
Provides LAN Interface, transmitting/receiving compressed voice
or signals over IP network.
Provides Auto Negotiation function (Set to ON/OFF by the switch
setting).
Used together with maximum of four 4VCT (PN-4VCTI) cards
(16-channels).
10BASE-T/100BASE-TX twisted pair cable is connected directly
to this card.
PN-24PRTA PRT ISDN Primary Rate (23B+D) Interface Card
Provides a built-in D-channel Handler (DCH).
PN-30PRTA PRT ISDN Primary Rate (30B+D) Interface Card
Provides a built-in D-channel Handler (DCH).
PN-4RSTB MFR 4-line MF Receiver, MFC Receiver/Sender Card
Used for MF/MFC-R2 Signaling on DID/DOD trunks.
Maximum four cards can be provided per system, including the
PN-4RSTC/PN-4RSTC-A card.
PN-4RSTC CIR 4-line Caller ID Receiver Trunk Card
Used for Caller ID (CLASS SM) on analog trunks.
Maximum four cards per system, including the PN-4RSTB card.
PN-4RSTC-A CIR 4-line Caller ID Receiver Trunk Card
Used for Caller ID (CLASS SM) on analog trunks.
Maximum four cards per system, including the PN-4RSTB card.
PN-SC00 CCH Common Channel Handler Card
Transmits/receives signals on the common signaling channel of
No. 7 CCIS.
PN-SC01 DCH D-channel Handler Card
Transmits/receives signals on the D-channel of ISDN Primary
Rate (23B+D) interface or WCS Roaming interface.
PN-SC03-B ICH ISDN-channel Handler Card
Provides the D-channel signaling interface and controls maximum
four ILC cards (Layer 2 and 3).
JULY/1/2006
EQUIPMENT NAME AND FUNCTION
To Next Page
Loading...
