– 446 – NWA-008841-001 Rev.5.0
90ch3003.fm
Switch Settings
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
SENSE
(Rotary SW)
NOTE 1
0-3 Not used
4-F Set the switch to match the AP Number (04-31) to be
set by CM05.
MB (Toggle SW)
NOTE 2
UP For make-busy
For normal operation
MODE
(Rotary SW)
0, 1
0 Auto Negotiation ON NOTE 3
Auto Negotiation OFF
(Ethernet 10 Mbps/100 Mbps change
by SW2-1) NOTE 3
2-F Not used
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 3: When you set the MODE switch of the IPT card to 0 (Auto Negotiation On), the communication
mode (Full-Duplex/Half-Duplex) and the communication speed (Ethernet 10 Mbps/100 Mbps)
of the Ethernet are adjusted to the switching HUB automatically. When you set the MODE
switch to 1 (Auto Negotiation Off), the communication mode of the Ethernet will be fixed to
Half-Duplex. And the communication speed will be set by SW2-1.
Continued on next page
F
4
AP No.
SW1-4: ON
04 05 06 07 08 09 10 11 12 13 14 15
SW1-4: OFF
20 21 22 23 24 25 26 27 28 29 30 31
SW No.
456789ABCDEF
ON
DOWN
1
PN-IPTB (IPT)
To Next Page
Loading...
