CHAPTER 1 GENERAL INFORMATION
– 35 – NWA-008841-001 Rev.5.0
90ch1001.fm
Line/Trunk Card Name and Function
NOTE: IP-PAD (PN-32IPLA) card does not support FAX relay.
Continued on next page
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-32IPLA/
PN-32IPLA-A
IP-PAD 32-channel IP-PAD Card
Provides LAN Interface, Packet Assembly/Disassembly to accom-
modate Legacy Line/Trunk interface.
Provides voice compression DSP control functions such as voice
compression control, DTMF relay and FAX relay.
• Voice compression protocol: G.711 (64Kbps)
• FAX protocol: Pass-through (G.711) NOTE
Used together with maximum two 16VCT cards.
Provides Auto Negotiation function (Set to ON/OFF by the switch
setting).
Two cards can be accommodated per built-in FP/FP card, maxi-
mum 8 per system.
100 BASE-TX twisted pair cable is connected directly to this card.
PN-4LCC LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
PN-4LCD-A LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides momentary open and Message Waiting Lamp control,
Line Test functions for each circuit.
Equipped with +80 V DC-DC on-board power supply.
PN-4LCE
[For
Australia]
LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
PN-4LCF
[For
Australia]
LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Message Waiting Lamp control, Line Test functions for
each circuit, and reverse function for only No.3 circuit.
Equipped with +80 V DC-DC on-board power supply.
PN-4LCK
[For China]
LC 4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
OCTOBER/31/2005
EQUIPMENT NAME AND FUNCTION
To Next Page
Loading...
