CHAPTER 1 GENERAL INFORMATION
– 38 – NWA-008841-001 Rev.5.0
90ch1001.fm
Line/Trunk Card Name and Function
Continued on next page
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-2ODTB
[For
New Zealand/
UK/EU]
ODT 2-line Out Band Dialing Trunk Card
Used as either a 2-wire E&M trunk or a 4-wire E&M trunk.
Equipped with –48 V DC-DC on-board power supply.
Both No. 0 and No. 1 circuits must be set to the same purpose
(2-wire or 4-wire) in one card.
PN-4ODTA ODT 4-Line Out Band Dialing Trunk Card
Used as either a 2-wire E&M trunk or a 4-wire E&M trunk.
–48 V DC power (PZ-PW122 card) is required when using the sig-
naling type I.
When it accommodates in the LT08 to LT11 slots of the PIM, connect speech
line circuits 2 and 3 with the CN1 connector on the front side of the card.
PN-4RSTF
[For North
America/
Asia exclud-
ing China]
SDT 4-line Sender Card for Caller ID Display on analog Single Line
Telephones
PN-4LLCB is required.
PN-4RSTF-A
[For North
America/
Asia includ-
ing China]
SDT 4-line Sender Card for Caller ID Display on analog Single Line
Telephones
PN-4LLCB is required.
PN-4RSTH
[For Europe]
SDT 4-line Sender Card for Caller ID Display on analog Single Line
Telephones
PN-8LCAD is required.
PN-8RSTG PBR 8-line PB Receiver Card
Used for a PB station line, DID or tie line.
PN-RTA RTA In-Skin Router Card
10/100BASE-TX: 1, 10BASE-T: 1, RS-232C (D-sub 9pin)
Maximum 8 cards per PIM
PZ-M649 DTI T1 Digital Trunk Interface (1.5 Mbps) Card
Mounted on PN-RTA Card
T1 Digital Trunk Interface: 1
Built-in CSU
NOVEMBER/15/2006
EQUIPMENT NAME AND FUNCTION
To Next Page
Loading...
