CHAPTER 1 GENERAL INFORMATION
– 58 – NWA-008841-001 Rev.5.0
90ch1001.fm
NOTE 1: When mounting the PN-4CSIA-A card to the PIM that the PN-4LDTA or PN-4LLCB card is
mounted, the mountable number of cards are limited as shown below.
CARD NAME MOUNTING CONDITIONS
PN-4CSIA
PN-4CSIA-A
Maximum of four cards can be mounted per PIM, maximum of 32
cards per system. PN-4CSIA/PN-4CSIA-A card is to be mounted only
in the even number slot of LT00-LT07. When PN-4CSIA/PN-4CSIA-
A card is mounted in the LT00, LT02, LT04, LT06 slots, only applica-
tion processor cards can be mounted in the LT01, LT03, LT05, LT07
slots which are the adjoining right side slots to the PN-4CSIA/PN-
4CSIA-A cards mounting slots. NOTE 1
PN-4LLCB When PN-4LLCB (LLC) is used for controlling message waiting
lamp, the card is to be mounted in the LT00-LT07 (When PN-4LLCB
is not used for controlling message waiting lamp, the card can be
mounted in the LT00-LT11.).
PN-4ODTA • When PN-4ODT card is mounted in the LT00-LT07 slots, allows all
speech lines to be accommodated from the BWB connector.
• When PN-4ODTA card is mounted in the LT08-LT11 slots, since
speech lines circuit 2 and 3 cannot be accommodated from the
BWB connector, connect with the CN1 connector on the front side
of the card.
Number of
PN-4CSIA-A Card
Number of PN-4LDTA/
PN-4LLCB Card
012
19
26
33
40
OCTOBER/31/2005
MOUNTING CONDITIONS OF CIRCUIT CARDS
To Next Page
Loading...
