NEC Univerge SV8100 - Page 1000

Issue 1.0 UNIVERGE SV8100
2 - 976 Station Hunt
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
To make a Step Call:
1. Place a call to a busy extension.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
16-01-03 Department Group Basic Data
Setup – Department Routing
When Busy (Auto Step Call)
Assign if a call to busy station hunts
(1) or not hunts (0) to the next
available member of the Hunt Group
(Department Group).
 Refer Department Calling on
page 2-343 to set up the
Department Group.
0 = Normal (Intercom
caller to busy
department member
hears busy)
1 = Circular (Intercom
callers to busy
department member
routes to idle member)
(default = 0)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
In an extension Class of Service,
turns On (1) or Off (0) Call Queuing to
the extension. This must be set to (0)
for Station Hunting to work.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
In an extension Class of Service,
allows a busy extension to Manually
(0) or Automatically (1) receive off-
hook signals. This must be set to (0)
for Station Hunting to work.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3