NEC Univerge SV8100 - Univerge Sv8100 Issue

Issue 1.0 UNIVERGE SV8100
2 - 14 Account Code – Forced/Verified/Unverified
20-13-20 Class of Service Options
(Supplementary Service) –
Account Code/Toll Restriction
Operator Alert (Restricted
Operation Transfer)
In an extension Class of Service,
turns On (1) or Off (0) the Operator
Alert when a forced account code is
incorrectly entered.
0 = Off
1 = On
(default = 0 for COS
01~15)
3
21-24-01 Forced Access Dialing –
Emergency Number
000
21-01-14 System Options for Outgoing
Calls – Forced Account Code
Inter-digit Timer
The system waits this time for a
user to enter a Forced Account
code.
0~64800 (seconds)
(default = 3 seconds)
3
21-04-01 Toll Restriction Class for
Extensions
Use this option to assign a Toll
Restriction Class (1~15) to an
extension.
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
3
35-05-01 Account Code Setup – Account
Code Mode
For each Class of Service (1~15)
use this option to select the Account
Code Mode.
0 = Account Codes
disabled (None)
1 = Account Codes
optional
2 = Account Codes
required but not verified
(No verify)
3 = Account Codes
required and verified
(Verify)
(default = 0)
3
35-05-03 Account Code Setup – Account
Codes for Incoming Calls
For each Class of Service (1~15),
enter 1 in this option to Enable
Account Codes for incoming calls.
Enter 0 to Disable Account Codes
for incoming calls. If disabled, any
codes you enter dial out on the
connected trunk.
0 = Disable Account
Codes for incoming calls
1 = Enable Account
codes for incoming calls
(default = 0)
3
35-05-04 Account Code Setup – Hiding
Account Codes
For each Class of Service (1~15),
enter 1 to have the system hide
Account Codes on an extension
display as they are entered. Enter 0
to have the Account Codes
displayed.
0 = Account Codes
Displayed
1 = Account Codes not
Displayed
(default = 0)
3
35-06-01 Verified Account Code Table –
Verified Account Code
Use this option to enter data into the
Verified Account Code Table. You
can enter up to 2000 codes from
3~16 digits in length. For a wild card
@, press the LK 1.
Up to 16 digits
Enter: 1~9, 0,
#, @
(@ = Wild Card)
(default not assigned)
3
40-10-01 Voice Announcement Service
Option – VRS Fixed Message
Enable (1) or Disable (0) the system
ability to play the fixed VRS
messages (such as You have a
message).
0 = Not Used
1 = Used
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3