NEC Univerge SV8100 - Table 2-22 Selectable Display Message - Character Entry Chart

Issue 1.0 UNIVERGE SV8100
2 - 922 Selectable Display Messaging
Operation
To select a message:
1. Press Speaker + press the Text Message key (Program 15-07 or SC 751: 18) + enter digits to
append (if needed) + Speaker to hang up. Skip the remaining steps.
2. (Optional for messages 1~8 and 10.)
Dial the digits you want to append to the message.
 You can append messages 1~8 and 10 with digits (e.g., the time when you will be back). Enter the time in 24-hour
format.
3. Press Speaker to hang up.
 Intercom calls to extensions with Selectable Display Messaging set receive a DND signal and receive the display
message on their telephone display instead of ringing the extension based on the setting in Program 20-01-02.
 To allow calls to ring through and have the message displayed on the calling extension display, cancel DND by
pressing DND + 0.
Table 2-22 Selectable Display Message – Character Entry Chart
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | } > <
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, a-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & <space> ( )
 Enter characters:
 + , - . / : ; < = > ?
# Accepts a numeric entry from the user when setting a display message.
e.g., time or date. Back at ##:##
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the right.