UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1007
LAN Connection:
35-02-17 SMDR Output Options – Print
Account Code or Caller Name of
Incoming Call
Determine whether the Account
Code (0) or Caller ID name (1)
should appear in the SMDR record.
By default, the Account Code is
displayed.
Program 35-01-08 must be
set to 0 for this entry to be
followed.
0 = ACC
1 = CNAME
(default = 0)
3
35-02-18 SMDR Output Options – Print
Mode for Caller Name of
Incoming Call
Select whether to display up to 16
characters of the Caller Name on
the same line as the call record (0)
or if a line feed should be added
and up to 24 characters of the
Caller Name is displayed on the
following line (1). If the line feed
option is selected, the Caller Name
is displayed on the next line as :
NEXT Caller Name. The default
entry for this option is 0.
This setting works regardless of
the setting in Program 35-02-15.
With this option set to 1, if
your communications
program (such as
HyperTerminal) has the line
wrap option enabled in the
ASCII setup, an additional
line break may appear above
the Caller name line.
0 = Normal
1 = Line Feed
(default = 0)
3
35-03-01 SMDR Port Assignment for Trunk
Group
Assign the SMDR port for each
trunk group. This is the SMDR port
to which the incoming call
information should be sent.
Trunk Group: 1~100,
SMDR Port: 1~8
(default = 1)
3
35-04-01 SMDR Port Assignment for
Department Groups
Assign the SMDR port for each
department group. This is the
SMDR port to which the outgoing
call information should be sent.
Department Group:
01~64
SMDR Port: 1~8
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-12-01 CD-CP00-AU Network Setup – IP
Address
When using an IP connection, set
up the IP address used to connect
from the CallAnalyst PC to the
system.
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.254.255.254
192.0.0.1 ~
223.255.255.254
(default = 192.168.0.10)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
