NEC Univerge SV8100 - Figure 2-4 Pcpro Connection Dialog

Issue 1.0 UNIVERGE SV8100
2 - 832 PC Programming
Connecting
As can be seen in Figure 2-3 PC Programming Overview, three connection types are available to PCPro/
WebPro.
If using PCPro, a user can connect directly, remotely using a modem or via LAN. A connection with the
system is made via the Connection Dialog in the application. (Refer to Figure 2-4 PCPro Connection
Dialog on page 2-832.)
 Direct connections are established using the RS232 serial port (COM Port 1) on the side of the
system.
 Modem (remote) connections are established via the internal CD-CP00-AU modem. To access the
modem, dial a trunk that is directed to the modem access service code (DIL or DID) or dial an
extension that is redirected to the modem access service code.
 IP (LAN) connections are established via the Ethernet connector on the CC-CP00 blade.
Figure 2-4 PCPro Connection Dialog
3) (Optional) Load
a defined
Connection
Account (can skip
steps 1~3 by using
this option.
1) Select
Connection Type.
If connecting to an
IPK II system,
select either Direct
or Modem
Connection Type.
2) To login, specify
the User Name and
Password.
4) To make the
connection to the
system, click
Connect.