NEC Univerge SV8100 - Table 2-20 Keys for Entering Names

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 773
Operation
Refer to Table 2-20 Keys for Entering Names for and explanation for using the keypad to enter names.
20-13-48 Class of Service Options
(Supplementary Service) –
Station Name Display
Determine if a station Number will
be displayed (On) or not displayed
(Off) in the LCD when the phone is
in an idle state.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-51 Class of Service Options
(Supplementary Service) –
Number and Name appear in the
Directory
Determine if an extension name
and number will be listed (On) or
unlisted (Off) in the directory.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
Table 2-20 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
 Enter characters:
 + , - . / : ; < = > ? π Σ σ Ω ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right
arrow Softkey instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3