UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 321
Cordless Telephone Connection
Description
Using an AP(R)-R( )/AP(A)-R( ) Unit for a DTR telephone, or an APR-L( ) for DTL telephones, an analog-
type cordless telephone can be connected to a multiline terminal.
The CD-4LCA
with PZ-4LCA Daughter Board, CD-8LCA with PZ-8LCE Daughter Board and the
SLTII(1)-U( ) ADP also support cordless telephones, but this feature refers to multiline terminal cordless
connection.
Conditions
A voice announced internal call to the multiline terminal does not ring the cordless telephone.
Only one cordless single line telephone can be connected to an APR-L( ), AP(R)-R( ), or
AP(A)-R( ) Unit.
When CO Prime Line is assigned to the associated multiline terminal, internal dial tone
cannot be transferred to the cordless telephone.
The cordless telephone requires a PBR circuit while dialing. When all PBR circuits are busy,
a busy tone is heard when the phone goes off-hook.
Depending on your environment, the maximum number of cordless devices used without
interference varies.
This feature works with analog-type cordless single line telephones.
The multiline terminal user and the associated cordless telephone user cannot talk to each
other.
An APR-L( ), AP(A)-R( ) or AP(R)-R( ) Unit with hookflash enabled follows the same
operating procedures as a single line terminal connected to a CD-4LCA
with PZ-4LCA
Daughter Board or
CD-8LCA with PZ-8LCE Daughter Board.
The multiline terminal LCD displays normal information for multiline terminal when a cordless
terminal is used.
When the multiline terminal user goes off-hook before the cordless single line telephone
user, a PBR circuit is not connected for the cordless single line telephone.
The cordless telephone must be installed within 3 metres (10 feet) of the AP(R)-R( ),
AP(A)-R( ) Unit or APR-L( ) Unit.
The following features are supported by an APR-L( ) AP(R)-R( ) or AP(A)-R( ):
Initiate conference
Change station name
To Next Page
Loading...
