UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 969
7. Press Hold.
8. Press Speaker to hang up or repeat steps 3~7 to program another System or Group Speed Dial bin.
To dial a System Speed Dialing number:
1. Go off-hook.
2. Press Redial.
3. Dial the System Speed Dialing storage code.
Unless you preselect, Trunk Group Routing selects the trunk for the call. The system may optionally select a
specific Trunk Group for the call.
If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.
Table 2-23 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ¢ £
## = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
FEATURE Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.
To Next Page
Loading...
