NEC Univerge SV8100 - Page 992

Issue 1.0 UNIVERGE SV8100
2 - 968 Speed Dial – System/Group/Station
Operation
To store an Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 753 (for system) or 754 (for group).
3. Dial system or group storage code.
 Initially, there are 1000 System Speed Dialing codes. There are Group Speed Dialing codes only if you define them
in programming.
4. Dial telephone number you want to store (up to 24 digits).
 Valid entries are 0~9, # and . To enter a pause, press Transfer. To store a Flash, press Recall.
 Enter @ for await answer before sending following digits on ISDN.
5. Press Hold.
6. Enter the name associated with the Speed Dialing number.
80-04-06 Call Progress Tone Detector Setup
– ON minimum time
Use to define the on minimum time
for the Call Progress Tone Detector.
1~255 (30+30-7680ms)
default:
Type 1 (DT) – 9 (300ms)
Type 2 (BT) – 9 (300ms)
Type 3 (RBT) – 25
(780ms)
Type 4, Type 5 – 0
3
80-04-07 Call Progress Tone Detector Setup
– ON maximum time
Use to define the on maximum time
for the Call Progress Tone Detector.
0~255 (30+30-7680ms)
default:
Type 1 (DT) – 0
Type 2 (BT) – 14
(450ms) [ET]
Type 3 (RBT) – 40
1230ms)
Type 4, Type 5 – 0
3
80-04-08 Call Progress Tone Detector Setup
– OFF minimum time
Use to define the off minimum time
for the Call Progress Tone Detector.
1~255 (30+30-7680ms)
default:
Type 1 (DT) – 1 (60ms)
Type 2 (BT) – 9 (300ms)
Type 3 (RBT) – 83
(2520ms)
Type 4, Type 5 – 0
3
80-04-09 Call Progress Tone Detector Setup
– OFF maximum time
Use to define the off maximum time
for the Call Progress Tone Detector.
0~255 (30+30-7680ms)
default:
Type 1 (DT) – 1 (60ms)
Type 2 (BT) – 14
(450ms)
Type 3 (RBT) – 115
(3480ms)
Type 4, Type 5 – 0
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3