Issue 1.0 UNIVERGE SV8100
3 - 2 Codes Tables
SECTION 3 USING HANDSFREE
The manual assumes each extension has Automatic Handsfree. This lets a user just
press a line key or Speaker Key to answer or place a call. For extensions without
Automatic Handsfree, the user must:
Lift the handset or press Speaker for intercom dial tone.
Lift the handset or press Speaker, then press a line key for trunk dial tone.
Table 3-1 Post Dialing Service Codes – Single Digit Post Dialing Codes
Code For this feature. . . When you are. . .
1
Handsfree Answerback / Forced intercom Ringing Changing the signaling mode of your outgoing
Intercom call
2
Department Step Calling Cycling to the next member of a Department Calling
Group
3~5
Not used
6
Voice Over Sending a Voice Over to a busy extension after
hearing Busy/Ring tone
7
Barge-In Barge into another station's active call
8
Voice Mail Leaving a message in a co-worker’s mailbox after
calling their busy or unanswered extension
0
Message Waiting Leaving a Message Waiting at a co-worker’s busy or
unanswered extension
#
Call Waiting / Camp-On / Callback / Trunk Queuing Call Waiting / Camp-On / Callback / Trunk Queuing
Off-Hook Signaling Sending off-hook signal tones to a busy extension
To Next Page
Loading...
