UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 361
Operation
Dial Tone Detection is automatic if enabled in programming.
21-01-04 System Options for Outgoing
Calls – Dial Tone Detection Time
If dial tone detection is enabled,
the system waits this time for the
Telco to return dial tone. When the
time expires, the system assumes
dial tone is not present. To disable
this time (and have the system wait
continuously), enter 0.
0~64800 (seconds)
(default = 5 seconds)
3
21-01-05 System Options for Outgoing
Calls – Disconnect Time When
Dial Tone Not Detected
If 14-02-11 is enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to
calls placed using Speed Dial,
ARS, Last Number Redial or Save
Number dialed. It does not pertain
to line key or Direct Trunk Access
calls.
0~64800 (seconds)
(default = 3 seconds)
3
21-01-06 System Options for Outgoing
Calls – Dial Pause at First Digit
If Dial Tone Detection is disabled,
the system waits based on this
time before sending dialed digits.
If using Dial Tone Detection, this
time should be set longer than the
time set in Program 21-01-05,
otherwise, if this time is set shorter
than Program 21-01-05, Dial Tone
Detection is satisfied and Program
21-01-05 is disregarded (not used).
0~64800 (seconds)
(default = 1 second)
3
Table 2-6 Dial Tone Detection Program Interaction
Method 14-02-05 14-02-11
Result if dial tone
not present . . .
Press a line key
- or -
Dial #0+ Trunk
number
0 0 Trunk hangs (does not disconnect)
0 1 Trunk hangs (does not disconnect)
1 0 Trunk drops
1 1 Trunk drops
Dial a Trunk
Group code
- or -
Automatically
through a feature
0 0 Trunk hangs (does not disconnect)
0 1 Trunk reroutes after time-out
1 0 Trunk drops
1 1 Trunk reroutes after time-out
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
