UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 881
Resident System Program
Description
When power is supplied to the system, the hardware configuration is scanned and Resident System
Program default values are assigned including terminal types (e.g. PGD(2)-U( ) ADP, DSS Console).
This enables immediate operation, even before the system is programmed to accommodate the individual
site requirements.
Conditions
Default assignments for Multiline Terminals are: LK 01~LK 08 corresponds to CO 01~CO 08.
DSS Console to Extension assignments for Attendant Add-On Consoles are not assigned.
Default Attendant Add-On Console key assignments are:
DSS Keys = 001~060
Stations = 101~160
First Initialization of the system returns all programming values to default. Without a PC-ATA
Compact Flash card installed, press and hold the SW1 (Load Switch) and toggle the Reset
(SW2) switch. Continue to hold the SW1 switch for approximately 5~10 seconds before
releasing. The system boots loading Resident System Programming.
Default Setting
None
System Availability
Terminals
Not Applicable
Required Component(s)
None
Related Features
None
To Next Page
Loading...
