UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 995
4. Enter the name. (Refer to Table 2-21 Selectable Display Messaging Defaults on page 2-919.)
Your name can be up to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
To program any extension name:
1. Press Speaker.
2. Dial 700
- OR -
Press the Extension Name Change key (Program 15-07 or SC 751: 55).
3. Enter the extension number to be named.
4. Enter a name. (Refer to Table 2-28 Keys for Entering Names.).
The name can be have to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
Table 2-28 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
← Á À Â Ã → Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú
å ä ö ü α ε θ β
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ¢ £
## = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to the right.
To Next Page
Loading...
