NEC Univerge SV8100 - Page 1090

Issue 1.0 UNIVERGE SV8100
2 - 1066 Synchronous Ringing
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
None
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-02-17 Analog Trunk Data Setup – Sync.
Ringing
Enable or Disable per trunk. 0 = Disable
1 = Enable (default)
3
20-15-01 Ring Cycle Setup – Normal
Incoming Call on Trunk
Used to define the ring cycle for
Normal Incoming trunk calls.
Ringing Cycle = 1~13
(default = 3)
3
20-15-02 Ring Cycle Setup – PBX, CES
Incoming Call
Used to define the ring cycle for
PBX and CES incoming trunk calls.
Ringing Cycle = 1~13
(default = 8)
3
20-15-04 Ring Cycle Setup – DID/DISA/
VRS
Used to define the ring cycle for
DID/DISA/VRS incoming calls.
Ringing Cycle = 1~13
(default = 8)
3
20-15-05 Ring Cycle Setup – DID/DDI Used to define the ring cycle for
DID/DDI incoming calls.
Ringing Cycle = 1~13
(default = 8)
3
20-15-06 Ring Cycle Setup – Dial-In in the
E&M Tie Line
Used to define the ring cycle for Dial
IN and E&M Tie line calls.
Ringing Cycle = 1~13
(default = 12)
3
20-15-07 Ring Cycle Setup – Door Box
Ringing for SLT
Used to define the ringing cycle for
Door Box Ringing for SLT terminals.
Ringing Cycle = 1~13
(default = 8)
3
20-15-08 Ring Cycle Setup – Virtual
Extension Ring
Used to define the ringing cycle for
Virtual Extensions.
Ringing Cycle = 1~13
(default = 8)
3
20-15-09 Ring Cycle Setup – Callback Used to define the ringing cycle for
callbacks.
Ringing Cycle = 1~13
(default = 11)
3
20-15-10 Ring Cycle Setup – Alarm for SLT Used to define the ring cycle for
Alarm for SLT terminals.
Ringing Cycle = 1~13
(default = 5)
3
20-15-11 Ring Cycle Setup – VRS Waiting
Message Incoming
Call
Used to define the ring cycle for
incoming VRS Waiting messages.
Ringing Cycle = 1~13
(default = 8)
3
22-03-01 Trunk Ring Tone Range – Ring
Tone Pattern
Assign Ring Tone Ranges to trunks.
Trunks ring extensions according to
the Ring Tone Range selected in
Program 22-03-0 and the settings
made with either Service Code 720
or Program 15-02-02.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)
3