NEC Univerge SV8100 - Page 1129

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1105
20-09-01 Class of Service Options
(Incoming Call Service) – Second
Call for DID/DISA/DIL/E&M
Override
Turns Off (0) or On (1) the
extension ability to receive a
second call from a DID, DISA, DIL,
or tie line caller.
 With this option set to 1, the
destination extension must be
busy for a second DNIS caller
to ring through. If the
destination extension does not
have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless
of this program setting.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
For each extension Turns Off (0) or
On (1) the extensions ability to
have multiple calls queued at the
extension. If Allowed, Tone
Override is automatic. Refer to
Program 20-13-06.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-05 Class of Service Options
(Supplementary Service) –
Intercom Off-Hook Signaling
Turns On (1) or Off (0) the ability of
an extension to receive Off-Hook
Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
automatically (1) or manually (0)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-34 Class of Service Options
(Supplementary Service) – Block
Manual Off-Hook Signaling
Turns Off (0) or On (1) an extension
ability to block Off-Hook signals
manually sent from a co-worker.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-35 Class of Service Options
(Supplementary Service) – Block
Camp On
Use this option to Turns On (1) or
Off (0) extension ability to block
callers from dialing
# to camp-on.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-18-06 Service Tone Timers – Interval of
Call Waiting Tone
Use this timer to set the interval
between Off-Hook Signaling alerts.
0~64800 (seconds)
(default = 10 seconds)
3
80-01-01
(39)
Service Tone Setup – Basic Tone
Number
Used to customize the service
tones in the system. Tone Override
is tone 39.
0~255 (default 0 = until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
3
80-01-02
(39)
Service Tone Setup – Ring Busy
Tone
Define Ring Busy Tone. Refer to Table 2-15
Service Tone Setup,
Program 80-01-02 on
page 2-558
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3