NEC Univerge SV8100 - Page 1140

Issue 1.0 UNIVERGE SV8100
2 - 1116 Transfer
15-07-01 Programmable Function Keys Extension users may want a
function keys programmed for
Transfer (code 06).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99 (Appearance
Function Code) (Service
Code 752 by default)
3
20-02-04 System Options for Multiline
Telephones – Retrieve the Line
After Transfer
Enable (1) or disable (0) an
extension ability to answer a call
after it is transferred, but before it is
answered.
0 = Not Holding (No
Keep)
1 = Holding (Keep)
(default = 1)
3
20-03-01 System Options for Single Line
Telephones – SLT Call Waiting
Answer Mode
For a busy single line (500/2500
type) telephones, set the mode
used to answer a camped-on trunk
call.
Modes:
0 = Press and release hookswitch
to pick up waiting call
1 = Press and release hookswitch
and dial Service Code 794 (Call
Waiting Answer/Split Answer for
SLT) to answer waiting call.
0 = Hookflash (Hooking)
1 = Hookflash + Service
Code 654
(default = 0)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turns Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-06 Class of Service Options (Hold/
Transfer Service) – Unscreened
Transfer (Ring Inward Transfer)
Turns Off (0) or On (1) an extension
ability to use Unscreened Transfer.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-11-07 Class of Service Options (Hold/
Transfer Service) – Transfer
Without Holding
Turns Off or On an extension ability
to use Transfer Without Holding.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-08 Class of Service Options (Hold/
Transfer Service) – Transfer
Information Display
In an extension Class of Service,
turns Off or On the incoming
Transfer preanswer display.
0 = Off
1 = On
(default = 1 for COS
01~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3