NEC Univerge SV8100 - Page 120

Issue 1.0 UNIVERGE SV8100
2 - 96 Automatic Route Selection
12-01-01 Night Mode Function Setup –
Manual Night Mode Switching
Turns Off (0) or On (1) any
extensions from activating Manual
Night Service.
0 = Off
1 = On
(default = 1)
3
12-01-02 Night Mode Function Setup –
Automatic Night Mode Switching
According to a preset schedule,
Enable (1) or Disable (0) Automatic
Night Service for the system. Make
sure to set the Service Patterns in
Program 12-02-01, Program 12-02-
02 and Program 12-02-03.
0 = Off
1 = On
(default = 0)
3
12-02-01 Automatic Night Service Patterns
–Start Time
Define the daily pattern of the
Automatic Mode Switching. Each
Mode Group has 10 patterns. These
patterns are used in Programs 12-03
and 12-04. The daily pattern consists
of 20 timer settings.
This option defines the starting time.
0000~2359
Refer to the SV8100
Programming Manual
for defaults.
3
12-02-02 Automatic Night Service Patterns
–End Time
Define the daily pattern of the
Automatic Mode Switching. Each
Mode Group has 10 patterns. These
patterns are used in Programs 12-03
and 12-04. The daily pattern consists
of 20 timer settings.
This option defines the ending time.
0000~2359
Refer to the SV8100
Programming Manual
for defaults.
3
12-02-03 Automatic Night Service Patterns
–Operation Mode
Define the daily pattern of the
Automatic Mode Switching. Each
Mode Group has 10 patterns. These
patterns are used in Programs 12-03
and 12-04. The daily pattern consists
of 20 timer settings.
This option defines the operation
mode that the system should be in
during each time number.
1~8
(default = 1 or 2
depending on time
pattern and time
number.)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3