NEC Univerge SV8100 - Page 1212

Issue 1.0 UNIVERGE SV8100
2 - 1188 Uniform Numbering Network
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to trunk groups
(1~100).
Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order.)
3
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
Set this option to ‘0’ so that the
F-Route table selected is
determined only by the digits dialed
without any relation to the day or
time of the call.
0 = Not Used
1 = Used
(default = 0)
3
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
Set the number of digits to be
analyzed by the system for ARS
routing.
Up to eight digits
(Use line key 1 for a
‘Don’t Care’ digit, @)
(default not assigned)
3
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
Select the Service Type (0 = No
Setting, 1 = Extension Call, 2 =
ARS/F-Route Table, 3 = Dial
Extension Analyze Table).
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
3
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional Data
Enter the additional data required
for the service type selected in
Program 44-02-02, either the
number of digits to be deleted or
the table number to be used.
1 = Delete Digit = 0~255
(255 : Delete All Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
3
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
If enabled (1), this option sends dial
tone to the calling party once the
routing is determined. This may be
required if the central office at the
destination does not send dial tone.
0 = Off
1 = On
(default = 0)
3
44-03-01 Dial Analysis Extension Table –
Dial
Set the Dial digits (24 digits
maximum) 1~9, 0 
#, @) to be
used for the Dial Extension
Analysis Table. When Program 44-
02-02 is set to type “3”, this
program sets the dial extension
analysis table. These tables are
used when the analyzed digits must
be more than eight digits. To enter
a wild card/don’t care digit, press
Line Key 1 to enter an @ symbol.
Up to 24 digits
Digits = 1~9, 0, , #, @
(Press Line Key 1 for
wild character @)
(default = Not assigned)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3