UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1203
System Availability
Terminals
N/A
Required Component(s)
Any Blade
Related Features
None
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
None
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-03-01 ETU Setup Use Program 10-03-XX to setup
and confirm the basic configuration
data for each blade. This program
represents different data depending
on the blade installed in the slot.
Please refer the SV8100
Programming Manual for a more
detailed description of this program.
The assigned data
varies depending on the
blade installed in the
slot. Please refer to the
SV8100 Programming
Manual for a more
detailed description of
the 10-03-XX programs.
3
90-34-01 Firmware Information – Pkg Name Use to list the package type and
firmware for the packages installed.
The data varies
depending on the card in
the slot.
3
90-34-02 Firmware Information – Firmware
Version Number
Used to view the package name
and firmware for each blade.
The data varies
depending on the card in
the slot.
3
To Next Page
Loading...
