NEC Univerge SV8100 - Page 128

Issue 1.0 UNIVERGE SV8100
2 - 104 Automatic Route Selection
26-11-01 Transit Network ID Table –
Transmit Network ID (Carrier ID)
Enter the Transit Network Selection
information element to be added to
an ARS call using an ISDN trunk.
This information element identifies a
requested transit network.
0000~9999
(Fixed four digits)
(default not assigned)
3
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
Select whether the ARS/F-Route
feature should use the time schedule
(0=not used, 1=used). If this option is
set to 0, the F-Route table selected
is determined only by the digits
dialed without any relation to the day
or time of the call. If this option is set
to 1, the system first refers to
Program 44-10. If there is a match,
the pattern defined in that program is
used. If not, the F-Route pattern in
Program 44-09 and time setting in
Program 44-08 are used.
0 = Not Used
1 = Used
(default = 0)
3
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
Set the Dial digits for the
Pre-Transaction Table for selecting
ARS/F-Route (eight digits max: 1~9,
0 
#, @). To enter a wild card/don’t
care digit, press Line Key 1 to enter
an @ symbol.
Up to eight digits
(Use line key 1 for a
‘Don’t Care’ digit, @)
(default not assigned)
3
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
Set the Service Type (0~3) for the
Pre-Transaction Table for selecting
ARS/F-Route.
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
3
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional Data
If a Service Type is set to F-Route in
Program 44-02-02, set which
F-Route table to be used.
1=Delete Digit = 0~255
(255 : Delete All Digits)
2=0~500 (0 = No
Setting)
3=Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
3
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
Determine if the Dial Tone Simulation
is On (1) or Off (0) for the
Pre-Transaction Table for selecting
ARS/F-Route. If enabled, this option
sends dial tone to the calling party
once the routing is determined. This
may be required if the central office
at the destination does not send dial
tone.
0 = Off
1 = On
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3