NEC Univerge SV8100 - Page 1321

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1297
4. Dial the VRS message number you want to record (01~48).
5. When you hear, “Please start recording” followed by a beep, record your message.
6. Press
# to end recording
- OR -
Hang up to save the message.
To listen to a previously recorded VRS message:
1. Press Speaker or lift the handset.
- OR -
At a single line telephone, lift the handset.
2. Dial 616.
3. Dial 5 (Listen).
4. Dial the VRS message number to which you want to listen (01~48).
 You hear the previously recorded message. If you hear a beep instead, no previous message is recorded.
5. Press # to hear the message again.
- OR -
To hear another message, dial 5 and then enter the message number (01~48).
- OR -
Hang up.
To erase a previously recorded VRS message:
1. Press Speaker or lift the handset.
- OR -
At a single line telephone, lift the handset.
2. Dial 616.
3. Dial 3 (Erase).
4. Dial the number of the VRS message you want to erase (01~48).
5. Press Hold (multiline terminal only) to cancel the procedure without erasing (and return to step 3).
- OR -
Hang up to erase the message.
To record, listen to or erase a VRS message if you call in using DISA:
1. Place call to the system.
 You hear dial tone.
2. After the system answers, dial the DISA password (normally 000000).
 You hear dial tone.