NEC Univerge SV8100 - Page 162

Issue 1.0 UNIVERGE SV8100
2 - 138 Call Duration Timer
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
To time your trunk calls:
1. Place a trunk call.
 The timer starts automatically.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-06 Class of Service Options
(Incoming Call Service) –
Incoming Time Display
If this option is set to 1, the
Incoming Call Time is displayed on
the multiline terminals LCD while
the telephone is ringing.
0 = Off
1 = On
(default = 0 for COS
01~15)
3
20-13-36 Class of Service Options
(Supplementary Service) – Call
Duration Timer Display
In an extension Class of Service,
turns On (1) or Off (0) a Call Timer
for the extension.
0 = Off
1 = On
(default = 1 for COS
01~15)
3
21-01-03 System Options for Outgoing
calls – Trunk Interdigit Time
(External)
The time the system waits for this
time to expire before starting the
Call Timer.
0~64800 (seconds)
(default = 5 seconds)
3