Issue 1.0 UNIVERGE SV8100
2 - 148 Call Forwarding – Park and Page
Operation
To have the system page you when you have a call:
1. Press Speaker (or lift the handset at the single line telephone) and dial 713.
2. When you hear, “Please start recording,” record your Personal Greeting.
If you already have Park and Page or Personal Greeting set up, you can dial:
3 to erase (the optionally HOLD to cancel the erase)
5 to listen (then # again to listen again)
7 to re-record
3. Dial #7.
4. When you hear, “Please start recording,” record your page and dial
# when the announcement is
complete.
A paging chime overrides the first four seconds of an announcement. Allow a delay in announcement recording
for chime time.
5. Dial the Page Zone that should broadcast your announcement.
For example, for Internal Zone 1 dial 701 + 1, or for Combined Paging Zone, 1 dial 1 + 1.
6. Dial the Park and Page type:
2 = All Calls
3 = Outside Calls Only
7. Press Speaker to hang up (or go on-hook at the single line telephone).
To pick up your Park and Page:
1. Press Speaker (or lift the handset at the single line telephone).
2. Dial
+ your extension number.
To cancel your Park and Page:
1. Press Speaker (or lift the handset at the single line telephone).
2. Dial 713 + 3.
3. Press Speaker to hang up (or go on-hook at the single line telephone).
40-10-01 Voice Announcement Service
Option – VRS Fixed Message
Enable (1) or Disable (0) the system
ability to play the fixed VRS
messages (such as You have a
message.).
0= Not Used
1= Used
(default = 0)
3
40-10-05 Voice Announcement Service
Option – Park and Page Repeat
Timer (VRS Msg Resend)
If a Park and Page is not picked up
in this interval, the Paging
announcement repeats.
0~64800 (seconds)
(default = 0 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
