NEC Univerge SV8100 - Page 256

Issue 1.0 UNIVERGE SV8100
2 - 232 Central Office Calls, Placing
11-12-14 Service Code Setup (for Service
Access) – Trunk Group Access
Define the service code which
should be used by an extension
user to select outgoing Trunk
Group.
MLT, SLT
(default = 704)
3
14-01-01 Basic Trunk Data Setup – Trunk
Name
Set the names for trunks. The trunk
name displays on a multiline
terminal for incoming and outgoing
calls.
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200
3
14-01-02 Basic Trunk Data Setup –
Transmit Level
Customize the transmit and receive
levels of the CODEC Gain Types for
each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
3
14-01-03 Basic Trunk Data Setup –
Receive Level
Customize the transmit and receive
levels of the CODEC Gain Types for
each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
3
14-01-07 Basic Trunk Data Setup –
Outgoing Calls
Use this option to Allow (1) or Deny
(0) outgoing calls on the trunk you
are programming.
0 = Deny (No)
1 = Allow (Yes)
(default = 1)
3
14-01-10 Basic Trunk Data Setup – DTMF
Tones for Outgoing Calls
For each trunk, Enable (1) or
Disable (0) the ability to hear the
DTMF of the digits dialed when
placing the outgoing call.
0 = Disable
1 = Enable
(default = 0)
3
14-02-05 Analog Trunk Data Setup – Dial
Tone Detection for Manually
Accessed Trunks
Use this option enable/disable dial
tone detection for directly accessed
trunks. If disabled, the system
outdials on the trunks without
monitoring for dial tone.
0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used
(default = 0)
3
14-02-11 Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
Use this option to Enable (1) or
Disable (0) the system ability to skip
over a trunk if dial tone is not
detected. This option pertains to
calls placed using Call Appearance
(CAP) Keys, Speed Dial, Automatic
Route Selection (ARS), Last
Number Redial or Save Number
dialed. It does not pertain to line key
or Direct Trunk Access calls.
0 = Disable
1 = Enable
(default = 0)
3
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
Select Loop start (0) or Ground start
(1) for the trunk.
0 = Loop Start (Loop)
1 = Ground Start
(Ground)
(default = 0)
3
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to Trunk Groups. You
can also assign the outbound
priority for trunks within the group.
When users dial up the trunk group,
they seize the trunks in the order
you specify in the outbound priority
entry.
 At default, all group are
assigned to Trunk Group 1.
Trunk Group Number:
0~100
Priority Number:
1~200
(default = Trunk Group
1, with priority in
ascending order)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3