NEC Univerge SV8100 - Page 308

Issue 1.0 UNIVERGE SV8100
2 - 284 Code Restriction, Dial Block
Related Features
Code Restriction
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-10-17 Service Code Setup (for System
Administration) – Dial Block by
Supervisor
Assign a service code used by the
supervisor to set Dial Block for
another extension.
MLT
(default = 601)
3
11-11-33 Service Code Setup (for Setup/
Entry Operation) – Dial Block
Assign a service code to use for
Dial Block.
MLT, SLT
(default = 600)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-08-08 Class of Service Options
(Outgoing Call Service) – Toll
Restriction Dial Block
Turns Off or On an extension ability
to use Dial Block.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
21-09-01 Dial Block Setup – Toll
Restriction Class with Dial Block
Assign a Code Restriction COS
(1~15) when the Dial Block feature
is used.
1~15
(default = 15)
3
21-09-02 Dial Block Setup – Supervisor
Password
Assign a 4-digit password used by
the supervisor to Enable or Disable
Dial Block for other extensions.
0~9, , #
(4-digit fixed)
(default not assigned)
3