Issue 1.0 UNIVERGE SV8100
2 - 354 Department Step Calling
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-07 Service Code Setup (for Service
Access) – Step Call
If required, customize the Step Call
service code to be used by an
extension user.
MLT, SLT
(default = 708)
3
11-16-01 Single Digit Service Code Setup
– Step Call
If required, use this option to
change the Department Step
Calling Single Digit Service Code.
(default = 2)
3
15-07-01 Programmable Function Keys Assign a function key Department
Step Calling (code 36).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
00 ~
99 (Appearance
Function Code)
(Service Code 752 by
default)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-08-12 Class of Service Options
(Outgoing Call Service) –
Department Group Step Calling
Turns Off or On an extension
ability to use Department Group
Step Calling.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
To Next Page
Loading...
