Issue 1.0 UNIVERGE SV8100
2 - 364 Dialing Number Preview
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
To use Dial Number Preview to place a call (multiline terminal only):
1. Do not lift the handset or press Speaker.
2. To preview any number, dial the number you want to call.
With VRS installed, you must press to preview the number.
To preview a Speed Dial – System/Group number, press Redial and dial the
Speed Dial – System/Group bin number you want to call.
The number is displayed.
3. To dial out the displayed trunk number, press a Line/Trunk Group key.
If the previewed number as a trunk access code (e.g., 0), you can press Speaker instead.
- OR -
To dial an Intercom number, press Speaker.
- OR -
To cancel the number without dialing it out, press Hold.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-08-05 Class of Service Options
(Outgoing Call Service) – Dial
Number Preview (Preset Dial)
Turns Off or On an extension
ability to use Dial Number Preview.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
To Next Page
Loading...
